--get::
Get the value for a given key (optionally filtered by a regex
matching the value). Returns error code 1 if the key was not
- found and error code 2 if multiple key values were found.
+ found and the last value if multiple key values were found.
--get-all::
Like get, but does not fail if the number of values for the key
If not set explicitly with '--file', there are four files where
'git config' will search for configuration options:
-$GIT_DIR/config::
- Repository specific configuration file.
-
-~/.gitconfig::
- User-specific configuration file. Also called "global"
- configuration file.
+$(prefix)/etc/gitconfig::
+ System-wide configuration file.
$XDG_CONFIG_HOME/git/config::
Second user-specific configuration file. If $XDG_CONFIG_HOME is not set
you sometimes use older versions of Git, as support for this
file was added fairly recently.
-$(prefix)/etc/gitconfig::
- System-wide configuration file.
+~/.gitconfig::
+ User-specific configuration file. Also called "global"
+ configuration file.
+
+$GIT_DIR/config::
+ Repository specific configuration file.
If no further options are given, all reading options will read all of these
files that are available. If the global or the system-wide configuration
file is not available or readable, 'git config' will exit with a non-zero
error code. However, in neither case will an error message be issued.
+The files are read in the order given above, with last value found taking
+precedence over values read earlier. When multiple values are taken then all
+values of a key from all files will be used.
+
All writing options will per default write to the repository specific
configuration file. Note that this also affects options like '--replace-all'
and '--unset'. *'git config' will only ever change one file at a time*.